OpencdaCI

[aamatrawy]

Hi all,
I need your support on how can I start opencdaCI module. Whenever I run v2v-carlaMobility-80211p, it keeps saying "Waiting for OpenCDA Control Interface to be ready."

[carlosrisma]

Hi @aamatrawy,

As there could be several reasons for the simulation to get stuck in "Waiting for OpenCDA Control Interface to be ready.", I would appreciate it if you could tell me at bit more about how you chose to do the installation.

• Did you install using conda ?
• Is the OpenCDA installation on the ms-van3t/ns-3-dev directory ?
• Have you setup the CARLA-OpenCDA.conf file as specified here ?
• When a simulation is launched, there should be an output file in your /tmp directory called "opencda_output_1337.txt", could you share the content of this file ?

Thanks a lot,
Carlos