Skip to content

Radxa Zero 3w w/ OpenIPC v1.9.5

Choose a tag to compare

View all tags
@JohnDGodwin JohnDGodwin released this 23 Jan 15:32
· 56 commits to master since this release
zero3w-v1.9.5
a062c21
This commit was created on GitHub.com and signed with GitHub’s verified signature.
GPG key ID: B5690EEEBB952194
Verified
Learn about vigilant mode.

This is a prebuilt image for the Radxa Zero 3w to stream OpenIPC video.

v1.9.5 Release Notes:

  • This image brings an update to the AP mode and a new webUI to the radxa groundstation. Long-press the old 40MHz_Toggle button, gpio_38, and the onboard wi-fi will enter AP mode and broadcast a wireless network called RadxaGroundstation with password radxaopenipc. Connect to this network and navigate in a browser to 192.168.4.1:5000 to enter the webUI where you can access DVR files and change groundstation settings. WebUI now supports the ability to change camera settings via wfb tunnel. Navigate to the Camera Settings page, read you current settings, make and upload changes, and reset camera services all from the your ground station.
Recording.2025-01-23.061729.mp4
  • Because there is no more need to ssh into the system, the Openipc.service now automatically starts on first boot. If one ever desires to access the cli, boot the system with your wfb-ng wifi cards disconnected and the stream will fail to launch, booting to cli.

Please perform the following steps.

  • Step 1 - Flash the image to either your onboard emmc or a micro SD card. Connect a screen and wireless cards to your radxa.

  • Step 2 - Re-plug in your sd card to your computer and a directory called /config should mount. Inside, navigate to the scripts folder. Set your desired screen resolution and refresh rate in the screen-mode file. Format is WxH@fps -- Common values would be 1920x1080@60, 1920x1080@120. 1280x720@60, 1280x720@120. This does not need to match your camera settings, you want to set it to either the highest framerate or highest resolution the screen is capable of.

    For smooth DVR playback, set the dvr-fps to the fps at which your camera is shooting. e.g. 60, 90, 120

    If you are using ground-based msposd, set your osd file to ground now.

  • Step 3 - Boot the system. If all your settings are correct and you have a wireless card attached to the usb for wfb-ng, then the openipc.service will begin.

note AP mode may not work the very first time you boot the system. Give the system a reboot and things will work.

This image includes DVR functionality; It requires a push button to be installed to the gpio header between physical pin 32 and 3.3v.

DVR is saved to the media folder in your root directory. DVR can be accessed either at /media or via the AP mode webUI.

  • Note: the openipc.service must be running for buttons to function.

new_gpio

This image has support for groundstation-side rendering of MSPOSD over the wfb-ng tunnel. To enable this functionality, go into /config/scripts/osd and change from air to ground. You must enable the MSPOSD forwarding on the camera for this to work.

Assets 3
Loading