PCB TODO

1. Invalid package for the controller
2. Controller's pin 8 shorted to ground
3. Power converter pin 7 (output) connected using thin wire
4. Lot of text labels mixed up on the silk layer
5. "Power" and "EEPROM" labels mixed up
6. Holes for shottki diode are too small
7. Holes for the radio module are too small
8. Shottki diode invalid polarity
9. Motor power wires are too thin
10. Motor disable line is actually motor enable
11. Motor enable must be connected to CCP2 (PWM mode)
12. Mixed up pins on the RS-232 connector
13. Missing power on the RS-232 driver
14. One of capacitors is connected to Vcc instead of Vdd
15. Pin 1 on the programming connectors should be more visible
16. Fix numbers of all components on the silk layer. Especially power sockets (input and stabilized)
17. L293 ground must be a heatsink