While configuring crazyflie2 with the out-of-the-box firmware, the box in which you would change the address in the config menu is greyed out. However, when configuring crazyflies in which I am using a custom version of the firmware, I am able to modify the address. Even so, after "changing" the address in this box and then writing/restarting the crazyflie, I am only able to connect to that crazyflie by using the default address (E7E7E7E7E7). Going back in to the config menu, it shows that the address is changed, but when I connect using a variety of methods (ROS, cfclient, etc.) I am unable to connect unless I again specify the default address. I even tried modifying the custom address in the firmware in the config file and writing that to some other address and then flashing that version of the firmware, but still to no avail.
While configuring crazyflie2 with the out-of-the-box firmware, the box in which you would change the address in the config menu is greyed out. However, when configuring crazyflies in which I am using a custom version of the firmware, I am able to modify the address. Even so, after "changing" the address in this box and then writing/restarting the crazyflie, I am only able to connect to that crazyflie by using the default address (E7E7E7E7E7). Going back in to the config menu, it shows that the address is changed, but when I connect using a variety of methods (ROS, cfclient, etc.) I am unable to connect unless I again specify the default address. I even tried modifying the custom address in the firmware in the config file and writing that to some other address and then flashing that version of the firmware, but still to no avail.