0.2.13

What's Changed

• fix M5StickS3 mic

0.2.12

What's Changed

• Fix M5PaperS3 touch wakeup from light sleep in Power Class by @tenth-tensor in #206
• Implementing deepSleep for Tab5 (ESP32P4). by @lbuque in #209
• Board/dualkey by @hlym123 in #204
• Add INA226 for StamPLC by @TinyuZhao in #211
• Fix some issue in PowerHub by @TinyuZhao in #212
• Fix PowerHub RTC wake up issue. by @TinyuZhao in #213
• Arduino Nesso N1: fix power off pulse by @felmue in #218
• Arduino Nesso N1: fix set led by @felmue in #220
• boards: Add StickS3 Support. by @hlym123 in #221
• Fix some error. by @hlym123 in #223
• Fix StamPLC RTC wake-up issue. by @TinyuZhao in #219
• 0.2.12 by @lovyan03 in #224

New Contributors

• @tenth-tensor made their first contribution in #206
• @hlym123 made their first contribution in #204

Full Changelog: 0.2.11...0.2.12

0.2.11

• Add M5.Led class for RGB LED (still under construction...)
• Add support for PowerHub
• fix M5.Power for NessoN1

0.2.10

• A temporary fix was implemented to address the issue where derived libraries could not be compiled due to the name change of the RTC class in the previous update.
• Fixed a bug that prevented the charging status of M5StackCore from being acquired correctly.

0.2.9

• Add support M5.Power.getBatteryLevel for CardputerADV.
• Improve M5.Rtc and add support RTC RX8130 for Tab5.
• The maximum number of multi-touch points supported by M5.Touch has been increased to 5 (previously 3).

0.2.8

• hotfix: remove "virtual" from M5.begin. ( Potential memory corruption bug fix )
• fix compile error for ESP-IDF v5.5 and ArduinoESP32 v3.3
• fix M5.Mic for PDM microphone
• fix M5.Power. * for Tab5
• change to allow StampS3 surface button to be used as M5.BtnB ( for Capsule / Dial / DinMeter )
• add support CardputerADV / AtomEchoS3R / NessoN1

0.2.7

• fix compile error

0.2.6

• add support Tab5
• add support ModuleDisplay for Tab5
• add support MBus with M5.getPin

0.2.5

• add M5.getButton method ( for related library )

0.2.4

• Fix SPI Bus error for ESP-IDF v5.4
• Add support for StampPLC
• fix clearDisplay for LCD models